A large share of the houses in Ada and Canyon counties sit on a crawlspace: a short, vented space between the ground and the floor framing, with the foundation walls around it and the plumbing, ducts and floor structure exposed above. It's where a house's problems go to be ignored. It's also where Ridgescan sends a rover on every full-service job.
Why moisture is the issue
Wood tolerates being wet for a while. It doesn't tolerate staying wet. Once wood stays above roughly twenty percent moisture content, the fungi that cause decay can get established, and rim joists, floor joists, sill plates and posts start losing strength while looking mostly fine from the hatch. Sustained moisture also brings the things that follow it: musty air that migrates upstairs, corrosion on ducts and fasteners, sagging insulation that stops insulating, and the pests that like damp wood.
Because the space is closed off and dark, none of that is visible from the living room, and most of it isn't visible from the hatch either. By the time a floor feels soft or a bathroom smells wet, the water has usually been there for a long time.
Where the water comes from here
The Treasure Valley is high desert. The ground is dry most of the year, which is exactly why wet crawlspaces surprise people. The water generally arrives one of five ways.
- Irrigation. Lawns and beds in the Valley run on sprinklers all summer, and a lot of neighborhoods have pressurized irrigation. A head that throws against the foundation, a bed that's watered every night against the house, or a line that leaks underground can put more water at the foundation in July than the sky does all year.
- Grading and downspouts. Soil that slopes toward the house, or a downspout that dumps at the corner, sends roof water straight down the foundation wall. Spring snowmelt and the valley's occasional hard rain show where this is happening.
- Plumbing. Supply lines, drain lines and the water heater all live in or above the crawlspace. A slow drip at a fitting can run for years. Bathrooms and kitchens are the usual suspects, and the thermal camera upstairs often points to the spot before the rover confirms it below.
- Ground moisture. Near the Boise River, along canals and in low areas with a high water table, the soil itself stays damp. A vapor barrier on the ground is what keeps that from evaporating into the framing. A torn, missing or half-covered barrier lets it through.
- The house's own air. A dryer vent or bath fan that terminates in the crawlspace, or a duct that has separated, blows warm, wet air into a cool space, and it condenses.
What the rover documents
A person inspecting a crawlspace enters through the hatch, moves as far as clearance, ducts, debris and standing water allow, and reports the rest as inaccessible. That's not laziness; a crawlspace a person can't safely enter is one the standard doesn't require them to enter. The result is that the far corners, the bays under the bathrooms, and the areas past the ductwork are the least documented parts of most reports.
Ridgescan's rover is a tracked camera platform low enough to pass under ducts and pipes. It drives the full footprint and records as it goes. The capture covers:
- The foundation walls from the inside: cracks, efflorescence (the white mineral bloom that water leaves behind), staining lines that show how high water has stood.
- The framing: joists, beams, posts and the rim, looking for staining, decay, sagging, improper notching and repairs.
- The vapor barrier: present, missing, torn, or displaced, and how much of the ground it actually covers.
- Standing water and wet soil, with location.
- Plumbing: active drips, corrosion, unsupported runs, and the water heater's surroundings when it's down there.
- Ducts and insulation: separated joints, crushed runs, insulation that's fallen or soaked.
- Vents and penetrations: blocked vents, dryer or fan terminations, pest entry points.
Where the rover sees staining or suspected moisture, a moisture-content reading on the framing is taken and reported as a Beyond SoP instrument reading. The report gives the number and what range it falls in, so "elevated" means something you can see. All of it lands in the crawlspace section of the report with the stills tied to the items, and the same route can be driven again after repairs or at the 11th-month inspection, so change over time is documented rather than argued.
What to do with a crawlspace finding
Most crawlspace moisture is fixable, and a lot of it is cheap: redirect a downspout, move a sprinkler head, re-lay the vapor barrier, support a sagging duct. The Ridgescan report puts each item under Safety, Major, Maintenance or Monitor, names the trade (plumber, general contractor, HVAC technician, or a structural engineer where framing is involved), and gives a budgetary range. If you'd like a written estimate, the findings can go to an independent registered general contractor; Ridgescan takes no fee from that contractor, and that's disclosed wherever quotes appear.
What you shouldn't do is take "limited access" as an answer on a crawlspace house. The part that couldn't be reached is the part most likely to be the problem.